MTX SW2 User Manual download pdf (Page 17)

Conﬁguration 17

AES-VMUX/-SFP User Manual Rev. G

Table 6.2 Start address,

DIP switch settings

DIP SW1 1,2,3,4 or 5,6,7,8 Start address

oﬀ,oﬀ,oﬀ,oﬀ 1

oﬀ,oﬀ,oﬀ,on 5

oﬀ,oﬀ,on ,oﬀ 9

oﬀ,oﬀ,on ,on 13

oﬀ,on ,oﬀ,oﬀ 17

oﬀ,on ,oﬀ,on 21

oﬀ,on ,on ,oﬀ 25

oﬀ,on ,on ,on 29

on ,oﬀ,oﬀ,oﬀ 33

on ,oﬀ,oﬀ,on 37

on ,oﬀ,on ,oﬀ 41

on ,oﬀ,on ,on 45

on ,on ,oﬀ,oﬀ 49

on ,on ,oﬀ,on 53

on ,on ,on ,oﬀ 57

on ,on ,on ,on 61

6.3.1 Input addresses

The input address switches always set where the AES input signals are multiplexed.

The start timeslot used is set with DIP SW1 5-8 according the above table. The address start points

hop over 4 addresses because the AES ports are always inputs or outputs in blocks of four. The 16

combinations with 4 dip switches cover the range of addresses in the multiplex (16 timeslots x 4 =

64). The other input ports are placed consecutively in the multiplex after the start address.

The audio of these physical input ports will be available in the multiplex for all the AES-VMUX

cards in the chain, unless they are overwritten by inputs on other cards that have overlapping

multiplex addressing.

6.3.2 Output addresses

The AES output signal routing may be set by the DIP switches in DIP mode, or with the Multicon

GYDA system controller.

The signal routed to the ﬁrst AES output port comes from the timeslot set with DIP SW1 1-4 if the

DIP conﬁg mode switch is on/up.

The other physical output ports have signals consecutively in the multiplex after this address.

The output port addressing may be individually controlled by the Multicon system controller if

the DIP conﬁg mode switch is oﬀ/down.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 36 37

No comments

MTX SW2 User Manual Page 17