MTX SW2 User Manual download pdf (Page 18)

Conﬁguration 18

AES-VMUX/-SFP User Manual Rev. G

6.3.3 System address planning

The number of timeslots in the multiplex used by the module depends on the number of input

ports in the module.

It is up to the user to ensure that the addressing is consistent and timeslots are not overwritten

(unless this is intended).

6.4 Method

1. First deﬁne the port directions on each module.

2. Arrange each site so that the modules with de-multiplexing channels come ﬁrst in the

SDTI chain.

3. Assign the addresses to the modules with multiplexing channels.

4. Assign the addresses to the modules with de-multiplexing channels.

Most conﬁgurations will be simpler than the last two examples here.

6.5 Examples

Figure 6.2 Key to example graphics

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

No comments

MTX SW2 User Manual Page 18