MTX SW2 User Manual download pdf (Page 23)

Conﬁguration 23

AES-VMUX/-SFP User Manual Rev. G

6.6 SDTI input control

If an optical is present on the module the input selector may be manually set to one of the inputs

or allowed to switch automatically.

If in DIP conﬁguration mode:-

6.6.1 SW2.4 Manual/Auto

• On: Manual, input is ﬁxed. SW2.5 setting is used

• Oﬀ: Auto, input will search for a Network SDTI audio signal. SW2.5 is ignored

6.6.2 SW2.5 Optical/Electrical

• On: Optical input is used

• Oﬀ: Electrical input is used

6.7 DIP conﬁguration mode

The AES output port routing and the SDTI input switch control may be controlled by the system

controller and stored in the module. The AES input routing and the AES port directions parame-

ters are always controlled with the DIP switches.

6.7.1 SW2.8 DIP conﬁg mode switch.

• On: The card will be conﬁgured with the DIP switches. The module will not accept com-

mands from the system controller but may be monitored.

• Oﬀ: The module will be conﬁgured with the internally stored conﬁguration and the AES

output routing and SDTI input may be controlled with FLP4 commands as listed in chap-

ter 6.

As with all Flashlink modules, stored conﬁgurations in the Multicon controller will be applied to

a module that is plugged into a running system, provided that the switch SW2.8 is oﬀ and that the

last module present in the system was of the same type. A module with SW2.8 on, plugged into

a running system will overwrite the stored conﬁguration in the Multicon controller with its own

conﬁguration.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 36 37

No comments

MTX SW2 User Manual Page 23